washers rear footpegs

Home › Forums › CB1100R Owners Club Forum › washers rear footpegs

  • This topic is empty.
Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • September 9, 2012 at 3:09 pm #9400
    Anonymous
    Inactive

    Have made the washers for the rear footpegs in stainless steel 1,5mm.
    Incase anyone need them,for clubmembers they are 9,= euro for one set left and right, included shipping worldwide.
    16586257351c4f1c5ff2e52c68de054362c7631b.jpg.

    Regards,
    Wim

    September 11, 2012 at 12:55 pm #10844
    BrianC
    Participant

    Wim, I’ll get my act together and paypal you for a set or two of these little suckers. Pretty sure they are the same as the CBX, coz it needs a set as well. I was putting the rear pegs back together a few weeks back and these guys gave me a bit of grief. By the way, I have put the new main footpeg rubbers on last weekend, looking good so far.

    September 11, 2012 at 2:39 pm #10845
    Anonymous
    Inactive

    Hi Brian,oke thanks.Yes on the CBX are they also, the pegs are the same.Mostly the hole where the little ball falls is worn.
    Have very good results with the sika 552,they are very tight!What have you used for glue?
    Regards,
    Wim

    September 12, 2012 at 1:20 am #10846
    BrianC
    Participant

    I had already bought the original sika you recommended before I saw your post on the 552 product. No problem, they look and feel tight, I’ll give them a bit of a strength test later.
    The price for two sets of these footpeg plates to Australia -18?

    September 12, 2012 at 9:27 am #10847
    Anonymous
    Inactive

    Yes Brian 18,= euro total.The sika 552 is what they say primerless,but test it the other type should do also,preperation is the important thing to be done.
    Thank you Brian,

    Best regards,

    Wim

    September 12, 2012 at 9:53 pm #10849
    Trevor Hughes
    Keymaster

    Hi Wim

    I would like 2 sets of these Footpeg washers please and have just sent 18 euro’s to your Paypal account. I don’t know how long it will take to produce the washers but you may be able to give them to Andre as I will meet him at Stafford 19th-21st October.

    Thanks

    Trev

    September 13, 2012 at 10:04 am #10852
    Anonymous
    Inactive

    Hi Trev,have them ready,will send them to your adress.
    Thanks,

    Wim

    September 14, 2012 at 12:49 pm #10855
    Trevor Hughes
    Keymaster

    Wim

    I have sent you a PM with my address details.
    Thanks again

    Trev

    September 19, 2012 at 10:15 pm #10931
    Trevor Hughes
    Keymaster

    Wim

    I have just received the footpeg washers and they are great. The quality of your work is fantastic.

    Thanks

    Trev

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.