Neutral wiring

Home › Forums › CB1100R Owners Club Forum › Neutral wiring

  • This topic is empty.
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • June 9, 2013 at 1:54 pm #9517
    BrianC
    Participant

    Can anyone describe (or post a pic) of the path that the neutral wire follows please? That is where it emerges from the small harness down to the switch.
    I didn’t really note how it went as I stripped the RD down, there was too much grease and rubbish around. It looks like it should go behind the oil pump cover / dipstick housing but the wire isn’t long enough. Going across the front of it down to the neutral switch just doesn’t look right.
    Thanks.

    June 11, 2013 at 2:14 pm #11530
    AndyL
    Member

    Brian,

    Hopefully this helps.

    Sorry its only an iPhone photo

    Andy

    [ATTACH=CONFIG]1065[/ATTACH]

    June 12, 2013 at 12:28 am #11532
    BrianC
    Participant

    Thanks Andy, that’s perfect.

    June 12, 2013 at 6:07 pm #11535
    Nat_P
    Member

    Andy,

    That bike looks a bit dirty to me, so can you clean it up a bit please.

    Regards,

    Nat.

    June 12, 2013 at 7:17 pm #11538
    AndyL
    Member

    @Nat_P 2166 wrote:

    Andy,

    That bike looks a bit dirty to me, so can you clean it up a bit please.

    Regards,

    Nat.

    Ha ha ha… look at that wire… bloody filthy it is

    ;)

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.